Akademik Veri Yönetim Sistemi
PHOTOMEDICINE AND LASER SURGERY, cilt.31, sa.7, ss.328-333, 2013 (SCI-Expanded)
Objective: The aim of this study was to evaluate the effects of different surface treatments on the pushout bond strength of fiber-reinforced posts to composite resin cores. Materials and methods: Twenty-five translucent glass fiber posts were divided into five groups according to surface treatment methods as follows: an untreated control group, a group coated with silicated alumina particles (Co-Jet system, 3M ESPE, St. Paul, MN), and three groups undergoing surface preparation with erbium: yttrium-aluminum-garnet (Er:YAG) laser under three different power settings (150, 300, and 450 mJ at 10 Hz for 60 sec at 100 mu s duration). After surface treatment, fiber posts were built up to a dual cure composite resin core. All of the specimens were set and sectioned perpendicularly along the long axis of the post using a saw. Two discs (thickness of 2 mm) were obtained from each post-core sample; finally, each group consisted of 10 samples. For artificial aging, the specimens were stored in water (37 degrees C) for 24 h and subjected to thermal cycling (5000 cycles, 5-55 degrees C, and 30 sec dwell time). Pushout tests were performed using a universal testing machine at a crosshead speed of 0.5 mm/min. The pushout pressure values were measured in MPa and analyzed using one way analysis of variance (ANOVA) and Tukey's honestly significant difference (HSD) post-hoc test (p < 0.05). Fiber post surface images were obtained using a scanning electron microscope (SEM). Results: The bond strength values ranged between 14,949 and 23,879 MPa. The lowest values were observed in the groups treated with the Er:YAG laser at 150 mJ. Irradiation by the Er:YAG laser at 450 mJ affected the bond strength significantly (p < 0.05). After Co-Jet sandblasting, the bond strength increased relatively (19,184 MPa). Conclusions: Er:YAG laser irradiation enhanced the bond strength of fiberre-inforced posts to composite resin cores depending upon the power applied; Co-Jet sandblasting also increased the bond strength.