Research Information System
Food Biophysics, vol.19, no.3, pp.503-516, 2024 (SCI-Expanded, Scopus)
Printing foods in the desired shape with minimal additives and their stability after printing are the most important points for 3D food technology. In this study, the effects of water (5%, 10%, 15%, and 20%) and salt (0.5%, 1%, 1.5%, and 2%) on the printability of meat paste were evaluated to achieve improved textural and rheological properties. The printing parameters were examined at every stage, starting from the line thickness of the printed product, until the final 3D printed product was obtained. Accordingly, meat printability determined using different ingredient flow speed (3, 3.5, 4, 4.5, and 5), fill factor (1.2%, 1.3%, 1.4%, 1.5%, and 1.6%) and distance between layers (1.2, 1.4, and 1.6 mm). Salt addition increased the firmness and consistency of the samples, while the viscosity, storage modulus, and loss modulus decreased with the addition of water. Considering the line thickness and outer length, the most appropriate shape was obtained with 10% water and 1.5% salt. The optimal ingredient flow speed, fill factor, and distance between layers at a constant printing speed (2500 mm/min) were 3, 1.2%, and 1.4 mm, respectively. Four-layer-infilled 3D-printed samples maintained their initial shape after cooking, regardless of the cooking method. However, only baked products maintained their initial shapes among full-infilled samples. Although water and salt have different functions in meat, the use of the appropriate ratio is necessary for 3D-printed meat-based products to provide printability and post-production stability. To sum up optimum parameters and road map for printing meat and meat products including leftover meats and low-value by-products were revealed.